What is your one-rep max if you lift 315 for 3?

Lifting 315 lb for 3 good reps points to a one-rep max of about 344 lb. The three common formulas put it between 334 and 352 lb: Epley gives 346.5 lb, Brzycki 333.5 lb and Lombardi 351.6 lb. It is an estimate from a formula, so treat it as a range.

Last reviewed: . These figures are estimates for healthy adults aged 18 and over. They are not medical advice, and they are not meant for pregnancy, medical conditions or anyone with a history of disordered eating. Medical disclaimer

How the three formulas treat 315 for 3

Each formula turns a weight and a rep count into the load you could lift once. They were fitted to different groups of lifters, so they disagree a little. For this set the gap between the lowest and highest answer is 18 lb.

315 lb for 3 reps by formula
FormulaEstimated one-rep max
Epley346.5 lb
Brzycki333.5 lb
Lombardi351.6 lb
Average of the three344 lb

Three plates a side for a triple is a common squat and deadlift benchmark.

What if you got more or fewer reps?

One extra rep at the same weight changes the estimate more than most people expect. 315 lb for 4 reps works out to about 354 lb, and adding ten pounds to the bar for the same 3 reps works out to about 355 lb.

Estimated one-rep max if you lift 315 lb for other rep counts
Reps at 315 lbEpleyBrzyckiLombardiAverage
1315 lb315 lb315 lb315 lb
2336 lb324 lb338 lb333 lb
3347 lb334 lb352 lb344 lb
4357 lb344 lb362 lb354 lb
5368 lb354 lb370 lb364 lb
6378 lb366 lb377 lb374 lb
8399 lb391 lb388 lb393 lb
10420 lb420 lb397 lb412 lb
12441 lb454 lb404 lb433 lb

The formulas agree most closely in the middle of the table and drift apart at the high-rep end, which is why sets of more than ten reps give shakier estimates.

Training weights from this max

Programs usually set the load for a session as a percentage of your max. From 344 lb, ninety percent is 310 lb and eighty percent is 275 lb. Round down to the nearest plates you can load.

Training weights from a 344 lb one-rep max
Percent of maxWeight
95%327 lb
90%310 lb
85%292 lb
80%275 lb
75%258 lb
70%241 lb
65%224 lb
60%206 lb
50%172 lb

How far to trust it

A formula cannot see your form, how hard the set really was, or which lift you did. A grinding last rep and a set stopped with two reps in the tank give the same input and very different true maxes. Research that compared prediction equations for the bench press, squat and deadlift found their accuracy differed between lifts.

An estimated max is a planning number. It is not an instruction to load it and try. If you test a true single, warm up fully and use a spotter or safety bars.

Use your own numbers

The one-rep max calculator opens with this page's example filled in. Change any field and the result updates. Nothing you type is sent anywhere.

Frequently asked questions

What is my one-rep max if I can lift 315 for 3 reps?

About 344 lb. Epley gives 346.5 lb, Brzycki 333.5 lb and Lombardi 351.6 lb, so the honest answer is a range of 334 to 352 lb.

Which formula should I use for 315 for 3?

Epley and Brzycki are the most widely used and sit 18 lb apart or less for this set. Using the average of several formulas avoids leaning on any single one.

What should I lift for a set at ninety percent?

Ninety percent of a 344 lb max is 310 lb. Round down to a weight you can actually load.

Does this work for squat, bench and deadlift?

The formulas are used for all three, but studies have found their accuracy differs between lifts. Estimate each lift from its own set.

Is it safe to try the estimated max?

Treat it as a planning number. A true max attempt carries more risk than normal training and needs a full warm-up and a spotter or safety bars.

Sources

  1. Epley B. Poundage chart. In: Boyd Epley Workout. Lincoln, NE: Body Enterprises; 1985.
  2. Brzycki M. Strength testing: predicting a one-rep max from reps-to-fatigue. J Phys Educ Recreat Dance. 1993;64(1):88-90.
  3. Lombardi VP. Beginning Weight Training: The Safe and Effective Way. Dubuque, IA: Wm. C. Brown; 1989.
  4. LeSuer DA, McCormick JH, Mayhew JL, Wasserstein RL, Arnold MD. The accuracy of prediction equations for estimating 1-RM performance in the bench press, squat, and deadlift. J Strength Cond Res. 1997;11(4):211-213.